Things You Will Learn
Learn about a range of different hydraulic designs. This section will show you some of the standard circuits used to control hydraulic systems.
Hydraulic Load Control Fundamentals
Examine a range of load control circuits to understand some of the problems and pitfalls of moving loads with hydraulics. We consider each circuit and discuss the pressure balances that make them work. We show you how to experiment with our valve simulations to explore the circuits and better understand how they work.
Please note that the fluid stiffness values have been reduced in our simulation to better demonstrate the potential problems when using different load control circuits. This can be seen in delays when lifting the cylinder and oscillations when it's stopped suddenly. The issues do appear in actual systems but are only a problem apart for highly dynamic or high accuracy control systems. Examples include:
- Cylinder creep due to spool leakage
- Uncontrolled cylinder dropping
- Meter out or meter out flow control
- Pilot operated check valve load holding
- Instability caused by long pipe lengths
- Back pressure issues
- Externally vented PO check valves
- Counterbalance valve
- Proportional valve with unvented counterbalance
- Vented counterbalance with proportional valve
Logic Circuit Designs
Learn about a range of logic control circuits to understand how they work and where they may be used. We show you how to experiment with our valve simulations to explore the circuits and better understand how they work. Approaches include:
- Directional valve equivalent
- Isolating slice
- Freewheel crossover valve
- Re-generation slice
- Relief/red. gives proportional control
- Relief valves give +/- accn control
- Free design mode
Hydrostatic Closed Circuit Drive System Designs
Learn the basic principles of closed circuit, hydrostatic drive system design. Content covers:
- Charge pumps
- Braking relief valves
- Flushing valves
- Holding brakes
- Low-Speed/high torque motors
Hydraulic Circuit Simulation Software
Experiment with a range of hydraulic circuit layout. This simulation program allows you to select from different hydraulic circuits and test how they work. You can add your own load and performance values to understand how your own systems will work. You can even build and test your own circuits. We will be adding lots of example training circuits within this software.
- Test a range hydraulic circuits
- Add real operating values to test actual circuits
- Design and test your own circuits
Applies to the following areas
This module applies to both mobile and industrial applications although much of the more comprehensive control features will only be used on industrial applications. Lower cost power units in the industrial sector are very similar to the simpler mobile power units.
Target Audience
People who are responsible for hydraulic equipment in the following ways:
Managing or purchasing hydraulic equipment.
Maintenance Engineers repairing hydraulic equipment.
Hydraulic equipment designs.
Previous knowledge required
Students are expected to be familiar with:
1. The operation of hydraulic fluid power equipment.
2. Understand hydraulic components and where they are used.
3. Able to read hydraulic circuit and their symbols.